|
Product Overview:
The PairMaster will check the
point to point wiring, commonly referred to as wire-mapping. This tells the
user whether or not the cable pairs, 1/2, 3/6, 4/5, 7/8, are wired correctly
at both ends. Green LEDs indicate Pass, Red LEDs indicate Fail. If a fault
is detected, the corresponding Fault Code is displayed on the large, two
digit, seven segment LEDs.
Near End Crosstalk (NEXT) The Near End
Crosstalk feature checks for excessive AC coupling between each pair in a
cable. Once again, if a fault is detected, the PairMaster will display the
Fault Code.
Cable Identification The PairMaster can
also identify a LAN Cable within a bundle. By connecting up to 16 available
Remote Identifiers to the workstation wall jacks, the PairMaster will
identify and display the number of the Remote Identifier connected to the
cable. The user can then easily document the network topology.
Overload Protection The PairMaster has
built-in Overvoltage Protection. When voltage from a Central Office Battery
is detected, the unit will flash (OL) and shut itself down.
Remote Identifier The Remote Identifier is
a small unit used in conjunction with the Triplett PairMaster for LAN Cable
identification. The Remote Identifier properly terminates the LAN Cable when
connected to the workstation wall jacks. It contains the necessary circuitry
to allow the PairMaster to verify proper wiring within the cable. Each of
the 16 Remote Identifiers has an overvoltaged LED which lights to indicate
the presence of damaging voltage.
|
3241 PairMaster Kit Includes:
|
|
|
16 |
Remote Identifiers |
|
1 |
RJ-45 Patch Cable |
|
2 |
RJ-45 In-Line couplers |
|
1 |
9 Volt Battery |
|
1 |
Instruction Manual |
|
1 |
Hard-Sided
Carrying Case |
|